Setting up an AirTrack is a straightforward task, but there are a few essential tips and tricks that can help you quickly and efficiently prepare your AirTrack for training. By following these steps, you can ensure your AirTrack is set up correctly, allowing you to start training as soon as possible. Proper setup not only saves time but also maximizes the performance and longevity of your AirTrack.

Start by removing the bag from the AirTrack Factory AirTrack. The easiest way to remove the bag is to roll the AirTrack out of the bag. After removing the AirTrack, unroll the AirTrack a little to make space and uncover the valves.

Now, take your Hikoki or OV10 blower and insert it into the valve. Both these blowers have a locking mechanism for handsfree inflation. When using the Hikoki blower, make sure to hold the blower when the AirTrack is about to fold itself out due to the building air pressure. When using the gray valve, make sure you connect the AirTrack with a twisting motion.

IMPORTANT: The most important detail when using the gray valve is to make sure the inside pin is pressed outwards! This will allow the air to remain inside the AirTrack when removing the blower. Even without having the valve cap on the valve, no air should escape from the AirTrack!

The black valves make for quick inflation, but it’s always recommended to top off the AirTrack with the gray valves for maximum pressure. Note that neither of the included blowers can damage the equipment, so don’t worry about keeping the blower in for too long.

When inflated, the pressure must be above 30 mBar. An easy way to feel if the pressure is right for you is to simply bounce on the AirTrack a few times. You should never be able to bottom out. When the pressure of the AirTrack is right for you, it’s time to start training!

Train safe, have fun, level up!